Home Gas Detection Equipment Control Panels MSA 9010/9020 LCD and 9020-4 LCD

MSA 9010/9020 LCD and 9020-4 LCD

Please Enquire

The control system 9010/9020 LCD provides maximum flexibility, simple operation, high reliability and superb performance at considerably reduced costs. In combination with the large range of MSA gas sensors, the 9010/9020 LCD excels in a variety of industrial applications there could be a presence of dangerous gas concentrations.

The 9010 LCD control module processes signals from one gas sensor while the 9020 LCD processes signals from two independent gas sensors. The system is also available as a single or dual channel wall mount and in ABS housings or as 19” rack version with up to 5 or 10 modules

The 9020-4 LCD is identical to the 9020 but is configured as a four-channel IP65 controller to suit marine and industrial applications.

For more information, please see leaflets 07-516.2 and 07-517.2.

ATEX II (1)G (2)G, MED 96/98/EC

Out of stock

Follow by Email
(0 customer reviews)
0 out of 5
  • 9010/9020 LCD
  • ATEX 94/9/EC compatible where applicable
  • Failure status for low AC/DC power
  • Over range EEEE latching
  • Series connected opto-isolators provide failure status
  • Redundant dual contact failure relay [select able latching/non-latching function]
  • Alarm threshold inhibit
  • Choice of measuring units–LEL-LELm-PPM-% Vol-g/m3 or blank
  • Operates with a complete range of gas sensors and transmitters including semiconductor sensors, conventional smoke and temperature sensors, manual call points, thermo-resistive cable
  • 4–20mA current loop accept [one person]
  • Full internal diagnostics
  • User-friendly configurable operation
  • Firmware can be easily loaded via laptop
  • Versatile system functions with logic levels
  • Adjustments via membrane keypads
  • Up to 20 channels per rack
  • Individual terminal blocks per module
  • Meets ATEX Directive 94/9/EC requirements
  • A multi-purpose version which accepts both bridge [mV] and active [4 – 20 mA] input signals
  • A cost-effective version operating on a4–20mA input signal is also available
  • Satisfies a variety of gas monitoring applications/industries
  • Inherent reliability minimises spurious alarms and unexpected “down-time”
  • No tools required for adjustments [operation by Access Code]
  • High density monitoring
  • 9020-4 LCD
  • ATEX 94/9/EC and MED 96/98/EC approved
  • 4-digit, 7-segment back lit Liquid Crystal Display – one for each measuring channel
  • High-brightness alarm LED’s on front door
  • Choice of measuring Units – LEL, LELm, PPM, %Vol, g/m3 or blank
  • Redundant dual contact failure relay with safety function
  • Alarm threshold inhibit
  • User-friendly software configuration by specific Access Codes
  • Each Channel has three alarm thresholds: Caution, Alarm, Warning
  • Analogue output signal for each channel with linearisation
  • RS-485 common serial interface ModBUS RTU data transmission
  • 4 –20 mA current loop calibration at Transmitter only [one person]
  • Full internal diagnostics
  • Versatile system functions with logic levels
  • Common alarm, horn and failure relay contacts available on terminal board
  • Sheet metal vibration-proof IP 65 enclosure with bottom gland plate for cable entry
Please follow and like us:


  • Marine
  • Industrial
Please follow and like us:


There are no reviews yet.

Be the first to review “MSA 9010/9020 LCD and 9020-4 LCD”

Your email address will not be published. Required fields are marked *


Please follow and like us: